Keep your water working and your plant running.
Cooling towers, steam boilers, reverse osmosis systems and wastewater treatment plants each run on a different water chemistry, but their common enemies are the same: scaling, corrosion, microbial growth and poor clarity. These problems increase energy consumption, shorten equipment life and push discharge limits. With our water treatment chemicals, Biyopol Kimya helps you run your plant’s water circuits efficiently, safely and in compliance with regulations.
The most common problems in the field
- Scaling in cooling towers: Water concentrated by evaporation deposits calcium carbonate on exchangers and fill; heat transfer and efficiency drop.
- Corrosion and scale in boilers: Dissolved oxygen and hardness cause pitting and scale in boiler tubes; fuel consumption rises.
- Fouling of reverse osmosis membranes: Scale and silica deposits shorten membrane life and increase pressure and energy demand.
- Microbial growth and biofilm: Biofilm both accelerates corrosion and blocks heat transfer; Legionella risk is an operator responsibility.
- Clarity and sludge in wastewater: Insufficient coagulation and flocculation lead to exceeded discharge limits and high sludge volumes.
The Biyopol approach
Scale inhibitor, corrosion inhibitor and biocide programmes are designed according to make-up and circuit water analysis.
Target cycles, blowdown and dose are optimised together, reducing water and chemical consumption.
The programme is verified in the field with coupons, conductivity and microbial counts.
Cans, drums and IBCs, TDS/SDS support and periodic site visits.
Recommended products
- BiyoScale – Phosphonate-based scale inhibitor for cooling towers
- BiyoBoiler – Boiler water conditioner and oxygen scavenger
- BiyoRO – Membrane antiscalant for reverse osmosis systems
- BiyoCide – Biocide for microbial control in cooling water
- BiyoFloc – Polymeric flocculant for wastewater treatment
- BiyoCorr W – Water-soluble inhibitor for closed-loop systems
Preparing for a trial: what we need from you
- Make-up water analysis (hardness, alkalinity, conductivity, silica, chloride)
- System type, volume and operating temperatures
- Current chemical programme and dosing equipment
- The problem you face (scale, corrosion, biofilm, clarity)
- Discharge limits and regulatory requirements
Frequently asked questions
How many cycles can a cooling tower run at?
It depends on water quality and the scale inhibitor programme; with the right programme, cycles can be increased to reduce water and chemical consumption.
How often should biocide be dosed?
Shock or continuous dosing is planned according to microbial count results; oxidising and non-oxidising biocides can be alternated.
How is a membrane antiscalant selected?
Scale and silica saturation are calculated from the feed water analysis and recovery rate; product and dose are set accordingly.
What packaging do you supply?
Depending on the product, cans, drums and IBCs are available.
Related product groups
Water Treatment Chemicals · Corrosion Inhibitors
Let’s trial it in your water circuit
Share your water analysis and system details; we will recommend a suitable programme and verify it with you at your plant.