Choosing a Mould Release Agent: Where Do Stains and Voids on Concrete Surfaces Come From?

When it comes to fair-faced concrete, precast façades and exposed concrete elements, surface quality is as important as strength. Stains, colour variations, air voids or pieces of concrete stuck to the mould after stripping usually point to a single cause: a release agent that was wrongly chosen or wrongly applied.

Common problems and possible causes

  • Sticking and tear-outs: Insufficient or uneven application, a product unsuitable for the mould surface.
  • Stains and colour variation: Over-application, product pooling in the mould or a contaminated mould surface.
  • Surface air voids: Excessively thick film, high-viscosity product, insufficient vibration.
  • Damage to the mould surface: Use of a product incompatible with the mould material.

Choose the right type

Mineral oil-based products (BiyoRelease Oil) are a common, economical solution for steel and plywood moulds. In environmentally sensitive projects and enclosed spaces, biodegradable, plant-based products (BiyoRelease Eco) stand out. Solvent-free emulsion-type products diluted with water (BiyoRelease WE) offer low consumption and a clean working environment.

Not just concrete

Release agents also play a critical role in polyurethane foam, rubber, plastics and metal casting. In these applications, heat resistance, multiple releases per application and not interfering with subsequent painting or bonding are important. BiyoRelease PU, BiyoRelease R and BiyoCast are our products for these areas.

Application matters as much as the product

  • Clean the mould before application; remove old concrete and release agent residues.
  • Aim for a thin, even film; more product does not mean better quality, it means problems.
  • Use suitable spray equipment; watch for pooling when applying with a brush.
  • Observe the product’s drying / film-forming time.
  • When switching to a new product, carry out a trial cast on a small area.

Calculate the cost correctly

The price per litre of a release agent is not on its own a correct basis for comparison. When consumption per square metre, effect on mould life, cleaning labour and surface repair costs are considered together, a higher-quality product often turns out to be more economical.

Frequently asked questions

How long before casting should the release agent be applied?

It depends on the product type. Emulsion-type products need a short waiting time for the water to evaporate and a thin film to form. If too much time passes between application and casting, the product may become dusty or contaminated. The waiting time in the technical data sheet should be followed.

Do biodegradable release agents perform worse?

Today’s plant-based products, when applied correctly, can perform close to mineral oil-based products. Nevertheless, a comparison through trial casts according to mould type and surface expectations is recommended.

Can I use the same product on steel and plywood moulds?

Many products can be used on both mould types, but since their absorbency differs, consumption and application method change. It should be borne in mind that plywood moulds may absorb more product in the first uses.

Conclusion

A flawless concrete surface is the combination of the right product, a clean mould and controlled application. We can determine together the product that suits your mould type and surface expectations.

Related products: Mould Release Agents

Let us choose the right product together. For a solution, sample and technical data sheet suited to your plant or project, contact us.

← All articles